problem grande punto 90 hp

[mecdoc]

I have problem with a great point in a few words I can not remove the blank that has from 1000 to 2200 , I tried to remap but it seems that any mod face on the mapp acc, you may not feel
I have to say that until now I
clean collett.asp
deleted from the map and physically egr
sost mis the mass air
controlled efficiency geometry variab
but nothing
the car has 130000km

[sebastiano345]

hello ,you would have more data?what you have mapped at least I had solved it by touching only 3 maps ,after 4 attempts ,keep in mind that you are a beginner but if you want I'll send you the gold and the mod that works so that you can put to confronto.prima edit and then remove the egr but

[Backgroop]

post your maps golds that mod and check actually where mistakes

[carlo abarth]

look at that, after a certain mileage, the screw geometry on those cars must be calibrated and the problem and it was empty!!!

I have problem with a great point in a few words I can not remove the blank that has from 1000 to 2200 , I tried to remap but it seems that any mod face on the mapp acc, you may not feel
I have to say that until now I
clean collett.asp
deleted from the map and physically egr
sost mis the mass air
controlled efficiency geometry variab
but nothing
the car has 130000km

[Elettrico]

I confirm that I already had experience on this

[sebastiano345]

but the g punto 90 hp has already geomeria variable...(what year?),(type, volts and kw),the frame.....but you know what,there are no data,you do not understand that car..***** and can you not give answers to the case.one should always be on that machine,but if one works in a shop generic that takes in hand several each week, it is difficult even so,sometimes there are variations in the ecu's fitted on the car in front of you.

[mecdoc]

sorry for the little info:
great point
the year 2007
ecu: marelli mjet
MJD6F3HW03P
num SW: 3443PB82
dis FIAT: 51806506
cod OMO : 6F3.PB25

[Emanu88]

Try to control the piegurgh that controls the geometry can? be successful that has been, or check the tubes that bring the depression to activate the geometry nn are ruined if they are cracked slightly increases the times of the command of the geometry, with the consequent increase of the timing of implementation, I hope this information was useful ciaooo

[mecdoc]

controlled the depression on the valve vgt I have a value of-0.9 bar

the file gp-mod ? without closing the egr

[mecdoc]

some straight raga!!!!!!!!!!