Hello all,
I deleted the egr valve on a Peugeot 307 1600 hdi (in the attachment you can find gold and file amended).
Diagnosis is opening percentage, 0%, but I find the errors P0489: exhaust gas recirculation circuit low and P1162: electrical circuit, position sensor EGR blocked.
Could you tell me if the valve ? successfully deleted? (as seen on the web it seems to you)
I think it is a problem in the wiring, do you think it might be cos??
Thanks
Before loading the file it gave you the error?
First, it gave a lot of errors on FAP and EGR, I don't remember if there were also these two. The luca stanca works and no errors. There are only these two errors on the egr that immediately after loading the files were not there. According to you, to the exclusion egr okay? The attached file ? without luca stanca.
Hello tinturia if the egr valve and damaged both electrically and mechanically not solve the problem by excluding from the ecu.. the valve must work.. surely that motor is provided with an egr valve to 6fili where 3 are for the position sensor, and 2 for the valve motor.. check it out well
The patience and virtue of the strong..
Ok, check. Thanks!
On the file ? excluded well, surely you'll have a problem with the egr.
If the car does not go into recovery ? can delete the dtc interested in and solve the problem.
Thanks Alfa159 q4.Originally Written by Alfa159 q4
The car is fine. I had thought of myself to delete the dtc interested but I don't know how to do that.
If I'm not mistaken, you should find the area of the map to them referred, and to clear the corresponding bits. Correct me if I'm wrong, please.
S? right, but do not ? simple
in your case the only solution ? disable the dtc, but not ? a simple thing to find the controls.
if it can? be of interest to you I can advise the online service of the forum
Write permission
Quote