Opinion the map and info about the address Seat leon EDC15

[angelolsp]

Hi guys since I have to remove the crap of the map that I found on the car, I would try to make it I...I accept any criticism I have followed the reasoning of the mm3... I have not touched the maps fumes and map the pedal why? from the driver I wanted to understand something more?...

and then I would like at least in fo on these addresses..

0773CE?
04CEAA?
04D0FA limiters torque for gear? I have not touched since? they do not require the pi? of x 85mm3 now
04D354?
04D46C AND THE FOLLOWING...?
04E29A injection ? it seems the shape of the rail on the common rail..can be pressure pump here?
056142??
0567a0 map similar to 04E29A...
0573CE??
05B4E4?? AS EVER SO LONG?

As already said I accept any criticism and advice I would like to be able to make a map with enough thrust to thank those who I follow?

[mikyrace82]

I'll help you so...

[angelolsp]

Thanks 1000 give a okkiata.delle changes that you think? I kpt something?

[angelolsp]

instead, with regard to the maps pedal seen that until now I've used the driver, according to me, from the values that I get from the spins are reversed, can you confirm?

[angelolsp]

I gave it a look...
1? what I have tried to calibrate the machine for 85mm3 or 85 mg? I think I have it made in mm3 as also said the magi on the old map ke I found on the car where it is required 108mm3 but in this file I talk about mg...what would be the conversion of mm3 in mg? ...the limiters ccoppia I made them a team to try to get to the limiter and cut fuel at 5200 and feel type shots aarivando the rev limiter... ke arise from the violence in which the motor comes to us as I understand...regarding illimitatore smoke I know that I have to increase it so as to not limit the gasolo but here we use winols and ecm I have not figured out how to change it in the table... of the duration I would see them in 2d...Thanks

[angelolsp]

70 visits..don't I deserve a little help ???

[angelolsp]

girls I need to know if and only if they mm3 or mg? can you tell me if no division by 0 and neglect the logic to do the tt team and do the increases in the percentage

[angelolsp]

Then I started from scratch and dho done this mod, more than the 70 mm3 or mg l not I still have not understood about the vag...even if the diagnosis I give? value 70 despite having set the limiters to 75...as iniettero next 70 km says the diagnosis or more km I set I?... however, I adjusted the maps main injections those pedals torque limiters turbo and rev limiter out of the driver more than I have touched other 2 maps out of the driver, which I think are always the injection I gave it a 10 x % fixed... and inoltreho tried to do the launch control that I found online...I accept everything give me a hand pleaseee!!!

[mikyrace82]

To calculate the duration in the PDE not ? difficult.The duration, have the first breakpoint, relating to the mg, and the second refers to the laps..Simple... the duration at constant rpm x vary the amount? the table values must be in the vertical, so if you want to reach the range of 70mg, change the last breakpoint, 55 and 60 with the values 60 and 70, then in the corresponding tables 60 mg the next to last line, in this case, copy all of the values of 100% and in the boxes of the horizontal 100%, seeing the differences of the last box, the values increase them multiply x2.Redo the map limiters fumes, doesn't it ? the one that the ecm called injection zoned. Breakpoints refer to the MAF, you may get them starting from the value 4500 about because if you close the egr and the MAF reading? a higher flow rate of air to a minimum.
The values should be if I'm not mistaken 13 parts from 4500 to get to the last box with a value of about 12000, which corresponds to 1200 mg vag x the maf. If you have a A/F 17 about the max load, ok.
I use a a/f at low loads of 18:1 until you get to the max of 17:1. The torque limiters of course you need to adapt them. The variable geometry, not keep it so closed, why? you will have an increase of the peak and an increase in the consumption of fuel. The map of pedal you could leave gold in the part that you have to 100% the value of 7000, and the lines below match (increasing values) up to 7000.... I hope is helpful for you...don't expect a map for free, it would not be right..

[angelolsp]

You don't want the map for free...inanxitutto thank you for your participation and aid..I just finished trying the map pushes well from 2500 up to 5300 but we can do better?? The limiter smoke then, and that map if I touched off the driver that I said that it seemed injection?? The launch control did not work could you tell me where I'm wrong??the last question you asked me to redo the map fumes but I am limiting myself in this mod don't get it to 75?? Thanks again