Read peugeot 206 plus 1.4 HDI

[tidus1985]

Hello all, I have a doubt comes to the reading and writing of the machine to a customer, ua peugeot 206 plus 1.4 hdi, the car in question is supposed to mount a bosch edc16 while stanamente I can do the data only with the driver of siemens six80x of the citroen and peugeot driver I do not read either the data, hw and sw 9660300280_9653451880 bed with protocol 29f400 PSOP ecu Siemens cirtoen 1.4d sid 80x, data that is read with kess clone (V1)

May the mountains this ECU?

the file ori already taken here on the forum, but can you confirm that ? can find this ecu on this car?

thanks in advance

[msport (exil77grande)]

the answer is easy,find the ecu and I can see that management mounts,the one that read write not write files to the case.

[tidus1985]

perfect I do come back tomorrow and check, thanks a lot msport I just thought of...what a fool!

[legendaryslave]

from the number ? a sid read and write with that protocol, those motors can have the best of both managers

[tidus1985]

Read I read with kess, but you must always write ricodificandola with ECM right ? the first that happens to me that I have to encode, the fiesta, which I did siemens couldn't even read

[legendaryslave]

No need to make the encoding and decoding serial is the programmer I know that the 806 does not do it with the kes1 , you don't have a gallo2

[polini]

you can confirm the cock 2, and also mag pro v4 2 do

[polini]

1.4 HDI engine psa show that mounts SID802 or siemens SID804

[tidus1985]

seeing the number of soft and hard after the encoding says that mounts sid 806

[tidus1985]

no rooster, the 806 I should write it but not read it, and the coding I have to do to edit it with the ecm and then ricodificarla, kess1 alias magpro v4.2