Mpps v5 edc16u31 locked

[cawadany]

Tonight I had a problem with the mpps v5. Audi a3 edc16u31, you ? stuck at 7% in writing, with a message telling me to send the log. I click ok and I score 0 volts, error 84 in the lower right. Disconnected the usb and connect and now go. For? does not identify the ecu and not c'? way to do nothing. Almost gave up I turn off the ignition, turn it on, fans on, for? identifies the ecu. After a few attempts I was able to write the file ori in the recovery and the drive ? game. Which pu? to have been the cause according to you? I have already? written several edc16 vag without problems, but this has made me damn...

[angelolsp]

The car was powered? Can be qualkevsvalzo voltage

[cawadany]

It was powered with a battery charger, I was about 12.2 v. Then, to be on the safe side I connected another drive on and I read 13 see, And after a couple of attempts I made.

[cinqueturbo]

It was powered with a battery charger, I was about 12.2 v. Then, to be on the safe side I connected another drive on and I read 13 see, And after a couple of attempts I made.

Could it be that, and the game for the fan of the car in motion?
and so to had a drop of voltage in the writing?

[oakley1]

Never-connected power supply... ? even a booster.. Too much interference.. L mpps ? able to write even with voltages relatively low maximum connecting a battery in parallel . Hello

[cawadany]

Never-connected power supply... ? even a booster.. Too much interference.. L mpps ? able to write even with voltages relatively low maximum connecting a battery in parallel . Hello

I don't think is the problem. And however ? a battery charger of the electronic ones.....

[oakley1]

That c enters.... Some boosters are electronic but have never stabilized 100% as pu? be a battery... How do you say that ? that's the problem... I do not find.. also Counting the fact that you managed to retrieve it.

[cawadany]

That c enters.... Some boosters are electronic but have never stabilized 100% as pu? be a battery... How do you say that ? that's the problem... I do not find.. also Counting the fact that you managed to retrieve it.

For me it's not ? the problem, I have written several always with the charger attached and zero problems.

[leandro89]

if you scored 0 volt pu? be a problem of cable maybe bad, or a impallo of mpps

[cawadany]

if you scored 0 volt pu? be a problem of cable maybe bad, or a impallo of mpps

And that's what I thought too. Strange that after the lock did not give me more? the voltage. I had to disconnect and reconnect the usb and then the hub. I would not be a problem with the cable or the pc. Last week I wrote always a EDC16 VAG without any problem..... Now I restored the pc to a restore point a few days ago......