Page 1 of 11 123 ... LastUltima
Results 1 to 10 of 104

View Hybrid

  1. #1
    THE AVERAGE USER
    Date Of Registration
    Jan 2013
    The resort
    Sicily-Catania...
    Messages
    438

    I'm unlucky I am, or what?

    Hi guys....
    Yesterday I was going to try the map on the skoda of my father, TDI engine, 90 hp, EDC15...A Golf virtually...Start reading, it asks you to disconnect the fuse11, I mappetta, recalculation of the checksum....Recheck, and load. Write done properly, 100%, and shooting sigh of relief...mahhh We are here. Around the picture, and all is silent. Not to be a part of! Try again, but nothing....I Do the ecu id without turning off the picture, and nothing, it says; the ECU is NOT FOUND....
    Solution? Retrieved from Msport....

    Now, these ecu, should be made with a lot of tranquility? by MPPS....Where is the problem?
    Ah, the voltage over 13, and pc to the network, and can be installed by even the antivirus.....I have a tremendous fear to try it on other cars :S
    Am I out of luck or what?
    I have to say that before this he had only written a Swift Nevertheless, 69cv.

  2. #2
    THE ACTIVE USER
    Date Of Registration
    Mar 2013
    The resort
    Palermo, sicily
    Messages
    1,128
    hello, at me ? happened with mpps a problem, say like with a grandepunto, but by forcing the write to the original file ? riparita quietly at the third stroke.
    sometimes mpps is some error but I think that is normal.

  3. #3
    THE AVERAGE USER L'avatar di sno74
    Date Of Registration
    Jul 2012
    Messages
    641
    voltage is very important to use a power supply attached to the battery and take off the interior lights to reduce power consumption of the voltage then goes to the first ever best.....

  4. #4
    THE AVERAGE USER L'avatar di alex68
    Date Of Registration
    Nov 2012
    Messages
    270
    Citazione Originally Written by Danny Visualizza Messaggio
    Hi guys....
    Yesterday I was going to try the map on the skoda of my father, TDI engine, 90 hp, EDC15...A Golf virtually...Start reading, it asks you to disconnect the fuse11, I mappetta, recalculation of the checksum....Recheck, and load. Write done properly, 100%, and shooting sigh of relief...mahhh We are here. Around the picture, and all is silent. Not to be a part of! Try again, but nothing....I Do the ecu id without turning off the picture, and nothing, it says; the ECU is NOT FOUND....
    Solution? Retrieved from Msport....

    Now, these ecu, should be made with a lot of tranquility? by MPPS....Where is the problem?
    Ah, the voltage over 13, and pc to the network, and can be installed by even the antivirus.....I have a tremendous fear to try it on other cars :S
    Am I out of luck or what?
    I have to say that before this he had only written a Swift Nevertheless, 69cv.
    have you tried the recovery mode.

  5. #5
    THE AVERAGE USER
    Date Of Registration
    Sep 2012
    Messages
    535
    I made a Polo 1.9 TDI 101 EDC15, with MPPS V5. Unplugged the fuse 11 and it all completed successfully. I would think a checksum problem, for? I think that if it was what you would have had to be able to identify the ecu and rewrite the file ori.....

  6. #6
    THE AVERAGE USER
    Date Of Registration
    Jan 2013
    The resort
    Sicily-Catania...
    Messages
    438
    Guys the tension was over 13,all off, and then on the network without an anti-virus... In recovey mode I tried, But nothing.... Ah, oraho. Light the airbag is turned on.

  7. #7
    THE AVERAGE USER L'avatar di sno74
    Date Of Registration
    Jul 2012
    Messages
    641
    see on the tastes drivers what you mark maybe you can figure out the reason...

  8. #8
    THE AVERAGE USER
    Date Of Registration
    Jan 2013
    The resort
    salerno
    Messages
    351
    Citazione Originally Written by sno74 Visualizza Messaggio
    see on the tastes drivers what you mark maybe you can figure out the reason...
    the indicator light airbag ? on why you have removed the fuse 11,but danny, tell me you shot the ecu or not because I did not understand?

  9. #9
    THE AVERAGE USER
    Date Of Registration
    Sep 2012
    Messages
    535
    Citazione Originally Written by mafani Visualizza Messaggio
    the indicator light airbag ? on why you have removed the fuse 11,but danny, tell me you shot the ecu or not because I did not understand?
    In my case, removed the fuse and no light on.

  10. #10
    BEGINNER
    Date Of Registration
    Aug 2012
    Messages
    9
    understand, also, to me a similar thing you have to be quick to turn on the car ignition and to write the original mode? recovery. try and let me know

Page 1 of 11 123 ... LastUltima

Write permission

  • You you can not post new threads
  • You you can not send answers
  • You you can not send attachments
  • You you can not edit your posts
  •