The Ecm does not find the driver

[ecucilacunta]

Hi,
I have an issue with ecm titanium 1.61.
I read in a bdm edc16c8 mounted on a 147 1.9 jtd 16v 140cv 2003. The reading took about 6 minutes(possible?)
when I go on the ecm to open the bin file, not I do not find the appropriate driver.
Can someone tell me the pu? give a hand, perhaps posting a procedure to get it right?
Use bdm 100 clone and software dimsport.

[cawadany]

Sure that the file read ? the original?

[emilground]

right, if the file is not ? the original is not recognized by the ecm. find an original file and compare it

[ecucilacunta]

I precise that file ? sure the original why? the car I bought it new and no one has ever put your hand over me.

[cawadany]

I precise that file ? sure the original why? the car I bought it new and no one has ever put your hand over me.

Then the file is not ? was read correctly. Evidence search online for a original file) via the codes hw and sw of your own and compare.

[ecucilacunta]

we do a bit of clarity:
I open the ecm and I open the file originale.bin
the ecm tells me no drivers are available, but in the database there are many drivers for this car. what criteria do I have to choose the driver?
if I select one when I open the file it tells me error calculating the checksum.

[angelo]

The friends you wanted to say: are you sure that the unit is not already been modified, in this case, the ECM does not find the driver.

[emilground]

really this is a strange thing, don't I ? never had a 147 which has the driver in the ecm.
however, the driver you have to choose based on the number of HW and SW watching the last 3 digits of the one and the other. if you find what the corresponding select it manually. If not then c'? do not worry because? in 2D you safely and curves acknowledge them without problems, you just need a little experience

[msport (exil77grande)]

even if the file is original and you are sure, maybe based on the number of ck that is different than the titanium does not recognize him,with regards to the compatible driver as I have already suggested, just to see the last 3 digits of both the hw and the sw you will find what you need.

[ecucilacunta]

The file is not recognized if I read with bdm100. I tried to read in bdm with the rooster and the driver is found. Pi? late poster? the two files,maybe someone can? understand where? the problem.