Mag pro error step n: 37 EDC16

[hackgen]

Hi guys,
I found a problem in the reading and in the writing of the maps through the serial port with mag pro v 4,
the machine ? a audi a4 140 of 2007 during the reading of the information of the control unit,
the program gives me the following error:

The ecu is Locked, unable to continue programming,"Error - Step n: 37".

We mapped the machine several times with both mag that with mpps any problems,
do you have a solution to part of the bdm?

For case, there is a counter that stops the unit if it is written with a defined number of times?

Thanks to early

[giarras]

try to disconnect the battery x is a p?, that to me is there are no limits to writing.

[hackgen]

Ok, I test it and place the result !! Thanks

[hackgen]

Mhhh, nothing to do test failed !! Other suggestions?

[sportknight]

you get error already? in the process of reading?

try to stick a charger

[hackgen]

It gives me error already? in the process of reading, as if there was something that stopped me ? for? had a doubt, this defect if I'm not mistaken ? out of it from when I changed the key, I would not be the encoding of the key tonight I try with the spare key.
The battery I scored 12.6

Other tests?

[pinotec]

It gives me error already? in the process of reading, as if there was something that stopped me ? for? had a doubt, this defect if I'm not mistaken ? out of it from when I changed the key, I would not be the encoding of the key tonight I try with the spare key.
The battery I scored 12.6

Other tests?

according to me the problem and due to the fact that you changed the key.
evidence that you do and unsolder the 95xxx and try to get her to tour with eep detached
or make a scod total on the eep and always try to counter it

I know there is no boot on edc16

[hackgen]

according to me the problem and due to the fact that you changed the key.
evidence that you do and unsolder the 95xxx and try to get her to tour with eep detached
or make a scod total on the eep and always try to counter it

I know there is no boot on edc16

Look, I don't remember if after changing the key I flashed or not,
I also tried with the old key, but nothing.

[hackgen]

To put it in bootmode you have to make a bridge between two pins?

So you have to disassemble?

I wanted to avoid to take it apart, if I have to disassemble aspect of the bdm and do with that.

Can that not c'? no procedure via serial?

[frantik3]

spent some time with ecusafe