Soldering

[neo]

Hi all,I want to open this new thread where we can share our experience in soldering*****incio I with a (pasta)for solder that I use and I am very satisfied with it. It is a mixture of ammonium Chloride (NH4Cl) and glycerin.Are the 2 products that you can find in any pharmacy .You mix + - 5/1 part 5 part glycerin, 1 part ammonium Chloride.Is used to clean the surfaces that is finished and in the same time lowers the temperature for soldering.

[egs]

I cleaning using trichloroethylene. With regard to the flux, use a cream of AMTECH, excellent. Much has also of good quality? of the welder.

[explode82]

I, however, after cleaning with trichloroethylene do not use anything why? first of all it annoys me to use all the ste of crap,then I prefer to buy one pond in particular that ? the treaty and has no need of dough to settle and so will not leave you even residues.........if then we talk about soldering and hot air for the mcu, I use the flux for the flash depends on the cases if I can avoid it depends on the components that are located around the flash

[guidotacco]

where to find the trichloroethylene pure?I don't find it to 100%

I, however, after cleaning with trichloroethylene do not use anything why? first of all it annoys me to use all the ste of crap,then I prefer to buy one pond in particular that ? the treaty and has no need of dough to settle and so will not leave you even residues.........if then we talk about soldering and hot air for the mcu, I use the flux for the flash depends on the cases if I can avoid it depends on the components that are located around the flash

[maku1977]

where to find the trichloroethylene pure?I don't find it to 100%

I find it at the coop

[maku1977]

and as far as the flux...... use a liquid flux that leaves no residue..... the pasta that I felt dirty.... and important tin of good quality

[carlo abarth]

also from the hardware store!!!

where to find the trichloroethylene pure?I don't find it to 100%

[filoxio]

where to find the trichloroethylene pure?I don't find it to 100%

I found it in the hardware..

do I need to replace a ecu marelli mjt the flash, that error while opening are skipped two legs.... having nothing to lose, I would like to replace it, I have a hot air station, I ordered the flash M58BW016DB80T3F , as it comes , being the first time that balance a flash of the genre, what are your tips on how to perform the weld and the products to use (flux, pasta, etc...)...
thanks

[guidotacco]

I found it in the hardware..

but 100%pure?

[filoxio]

contains dicloropropano and is called Trielax, the smell ? similar , I also use it to dissolve the para and it goes very well, it does in the same way as the old grease stain remover...then they are equal