pop-off Grande Punto Abarth
Sub punto abarth 155hp, ECU 662-661
It is possible to eliminate the operation of the electronic pop-off?
I remembered to have mounted a mechanical valve without that appeared in lights, and on this I do not want to know! (also leaving the original connected!)
If anyone has experience on it....
Thanks!
I know the pop-off ? however, the mechanical will notice? the electronics of the loss of pressure...
Anyway, many leave the original by disconnecting the return hose.
Your intent ? linked to the new pressure management high such as to justify a pop to vent outside or ? a desire "scenic"? Why? in essence, the pop-off ? pussy but does not gain performance, but...
Agree on everything there? you say, but the customer has expressed this desire.... and then I wanted to see if I can do that by lifting up the light!
But I imagined it was a difficult task...
The versions of the Abarth that fit the vent outside of the series, as they have done!?
Resolved,
you need to use pop open easily, so with a little spring preloaded. Otherwise, the sensor pressure values that are too high in certain conditions...
you can use a forge that works to vent outside, but has the sensor for the electronic...
Attention to water hammer on the throttle
The renault 5 gt turbo not, he did not even ...
I have mounted a pop off leaving mechanical connected to the connector on the pop off of the series...it works perfectly...!!
You , ? can delete the management ecuOriginally Written by matech
the problem you're complaining ? due to the spring is too hard or too soft pop mechanics that you have mounted
I have mounted several leaving the connector connected to the pop-off of the series... just to buy a pop off with the spring is very soft,or better yet, adjustable...never had problems turning on the lights or stuff like that..
Write permission
Quote