Immo OFF Bosch MS6.2

[jared_poe]

Hi all, I have read somewhere that to remove the immobilizer on these ecu just remove the 24C16 that or highlighted in the picture.
Me confirm?
PS the ecu ? a Iveco Stralis 480

[frantik3]

you have to riprogrammarla should be a 24c16

[jared_poe]

thanks for the reply frantik
so it's not just remove it??
for riprogrammarla what do you use? willem? xprog?

[frantik3]

both are good

[motorsport]

I confirm that I and a 24c16 you can? do both partial and total with the same file,if you are to make it a total off the immobox,partial all connected!!

[motorsport]

hello,I suggest to remove it from the pcb to make a correct reading,with willem + adapter soic...and go clear so avoid doing some reading wrong, read at least two times the file and check in the esa if they are the same!!

[jared_poe]

according to you, with a ludipipo programmer I can run quietly on the job? that sw is used to read and write?

[motorsport]

I never heard of this programmer so I can't help you,however if you take a willem or another, and including also the soft for reading and writing,then you will need an adapter to part SOIC-8!!

[frantik3]

you with ludipipo can't read it!!!!!

[bicio]

it goes very well ludipippo for the 24c16