convetrire a edc15-16 or a marelli mjd6f in "stand-alone"

[munro]

and can do such a thing with these ecu's??
seeking info...
thanks...

[munro]

it seems to me that you have not asked for the route with the exact angle of reentry into the atmosphere of the space shuttle on reentry from earth orbit???
translated: I think that it is not so difficult question...or ? started the festival of indifference ? I didn't realize it??

[msport (exil77grande)]

hahahah and viva festival munro certain that you crchi all eh? however, I do not think it is feasible that you say this.

[munro]

the discourse ? this msport: if I take, say, a complete motor with all the wiring and all the sensors needed to make it work with the ecu its dedicated...chess? bmw 330d e46 for example ..and I would like different in a bmw E30, it would be possible to do it without having to go crazy with the can bus,immo,the dial,the signals abs etc and make the motor to run independently without a lot of "gizmos" not useful at all or as if it were on a dyno???
in short, to make the ecu in a "stand-alone"? removing the first and immo can line?

[msport (exil77grande)]

I have never done such a thing, but from my point of view I don't think it can be possible otherwise there would be no ecu fully programmable and cost-absurd.

[bart]

Hello munro, I'm sorry, but I don't really understand...
Would staying in a motor, its special wiring and sensors and make it work outside of the machine ? been mounted? In practice, how to put it over the counter without then the remaining ecus of the car?
In this case I think that the thing is feasible! Well pi? complicated, however, if you wanted to mount it on other cars and pretendessi to make everything work via can...

[munro]

Hello munro, I'm sorry, but I don't really understand...
Would staying in a motor, its special wiring and sensors and make it work outside of the machine ? been mounted? In practice, how to put it over the counter without then the remaining ecus of the car?
In this case I think that the thing is feasible! Well pi? complicated, however, if you wanted to mount it on other cars and pretendessi to make everything work via can...

you understand......
run the engine out of his car on the source or on the bench or in another car without all the control units that serve not only the functioning of the same...

[munro]

for? msport on a lot of the ecu to the immo-off total already you can? to do for a long time,.....then the scab, the most coarse of the code is removed at the root, right??
then you should see if you could "put off" the can line of the ecu with, for example, the dial, or the abs-asr...e.g....I think it's feasible..certainly not easy, but I think doable..or not??

[msport (exil77grande)]

to this question I can not answer you, but I think it is here the achilles heel.

[munro]

in that sense achilles heel msport??not ? cos? as easy as I think???