Read Siemens Sirius 32 in serial with Kess V2

[Tinturia]

Hello to all,

I tried to read this ECU with Kess V2 via serial port OBD.
Also by varying the Pull-up resistor (to be chosen among the possible present in the setup section) I received the error message, the wake-up.
I've read several conflicting opinions on the ability to read this ecu with Kess V2 via serial...
I would like to understand something more.
I have read that:
- reads quietly
- reads only if the micro is infineon not if siemens
- you read the eprom dissaldandola
- ecu to be done in boot mode or anyway to tour

Someone can give me a hand to see if it really can be read with kess v2 in the serial?

Thanks

[micheleyr6]

hello...I this ecu with kess not ever made...in the manual does not say anything to put her in the boot...so should do it..
I will, or made one with the rooster and the due to put in the boot and then read and written safely.

[Tinturia]

Hello micheleyr6... thanks for your answer...I can't find either I references boot mode, but in serial give me error alarm, so evidently not communicating.

[micheleyr6]

hello I am attaching the procedure for the boot mode...put it in the boot and then try to read in the serial...likely to go..

[ugoboss]

these I have always made boot the tour, or desolder.