first steps on the ecm

[giobarbone]

hi guys sn was able to recover a file golds and a diver x try the program...
but I can make it go...
oxy load everything as it says in the manual... that is, before the file ori and then the driver , should be out next changes to the sessions injection and trubo...
but nothing...
help

[giobarbone]

I have the 2001...
the file and the drive sn-compatible, I checked the numbers...
driver A988_042.DRV
file ori 042_988ori
or am I wrong?

[giobarbone]

okok...then those messages are of little use?

[rego88]

fermi fermi.... someone in here can't remember how to use ecm 2001
you have to open the file ori... look at the info on the right what you say, what? that the real numbers come out.... after that... select the correct driver hypothesis if right on the 2 white columns, it leaves you to guess 0281001345 and under 9876543215 you will need to look for a driver 345_215 knowing, however, that the car we are talking about.... if instead the gold that you are using ? a jtd fiat edc16 you will find the column of the right edc16c39 or edc16A0 2345678909 and just... you know you're a sw 909 and ammattisciti to look for assumptions between the drivers of 147 something that has three numbers and initials after the trattino_909. select the driver and then loads the file ori.... if the driver ? correct... at the top after the written files, etc... go out,' injection, turbo limiters if you are not out anything about the driver nn ? correct.... I hope I was helpful!!

[giobarbone]

so if I understand well I have to see the last 3 numbers of the file ori and find it in the driver??

[marco]

------------------------------

[msport (exil77grande)]

maybe I was not clear enough,just above I clearly wrote that:
if you want some advice mail ori and mod always in the suitable section and open one of your posts without polluting other and we give you some advice otherwise you can contact the online service of the forum,I hope I was more clear this time.

------------------------------

[rego88]

very good.... you have to see the last 3 numbers of both the hw and the sw... if we talk about edc15 and some edc16.... the first one that you find ? always hw and the second sw.... if there is one, only.... they always talk about the sw.... on the driver.... the first ? always hw and the second sw

[giobarbone]

nn if I find anything? the driver nn okay??

[mecdoc]

see if this you can? be useful