Problem Golf 6 2.0 TDI

[Gica]

Hello to all, The car turns on, runs perfectly at idle, it moves into the plains without accelerating. In the moment in which they exceed the 1300-1400 rpm the engine will shut down abruptly with the lights of the glow plugs and the engine turned on. Error P0203, malfunction injector circuit No. 3. This happened after the cover of the ECU EDC17CP14) has been opened for reading in boot mode. I suspect that a small component on the opposite side of the pcb is blown away during the opening. If someone has an ecu the same open can check, I am attaching a photo of where I think something is missing. Thanks for any kind of help

[cinqueturbo]

Heeee the photos zoom not crisp.. remove a resistor? smd side and the measuring impedance are equal and the balances..
I don't understand how you arrived there.. use screwdrivers and chisels? with 50 euros you who work on these ECU's you are going to buy the extractors with the appropriate etc

[Gica]

Heeee the photos zoom not crisp.. remove a resistor? smd side and the measuring impedance are equal and the balances..
I don't understand how you arrived there.. use screwdrivers and chisels? with 50 euros you who work on these ECU's you are going to buy the extractors with the appropriate etc

Truly this is the ecu of my car. I shelter the cards of textile machinery. I used screwdrivers and I didn't escaped anyone. I only noticed that during the lifting of the lid, the silicone has pulled on the tab a couple of millimeters in that corner . I arrived there to find the fault. The missing component in the red circle is not a problem. In the yellow circle, I don't even know if we need the resistor or capacitor...
P. s. I'm attaching a photo to 500Kb, after allegatas becomes 129. I don't know how to do it better.

[cinqueturbo]

Snaps the photos, and please pack it in an archive in Winrar and it loads in enhanced mode..
I to tell the truth I noticed this in the red circle..

[cinqueturbo]

Aaaa but you can't download!!!!...

I try to make you understand where I mean..

there are 6 smd Blue to the right of the yellow circle that you made, one right after the first rise, or I'm wrong?

[Gica]

Thanks for the response cinqueturbo,sorry for the delay but I have problems with the PC. The smd blue are resistors, 220 ohm, but them where you say you do not think that there was already before. In the case to try it I try to solder a. The component that I see is what I put now inside a yellow rectangle. I enclose a photo rar. By the way, I can not download anything, not even what load I.....

[saetta]

hello extractors as they are done?

[cinqueturbo]

hello extractors as they are done?

lightning can't see the images?

[ugoboss]

I'm curious myself to see these extractors is appropriate.

[cinqueturbo]

What a disappointment...