Hi to all, I don't know if it is the right place or I had to write it in the section MPPS... in case of wrong section, I apologize.
I have a couple of questions to ask you about this machine (my mother's, I would like to use as a guinea pig) Fiat 500 1.3 Mjet 75hp.
1) This machine has a control unit compatible read / write with MPPS v13.02 ?
2) How can I identify the type of unit (model, hw, sw, drivers) without disassemble?
Thank you in advance
I have already responded in the other threads
I can't read it with Mpps v13.02 ... recognizes the id of the ecu...but the laws' disabled...Originally Written by lui93
Seen that recognizes the ECU before attempting to write I would say to post the data.. I would not be a 8DF
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
What is the meaning of this thing 8DF?
In fact, you're right...it's just that I think... the data that I have are:
Fiat Hardware Number: 51872447
Marelli Hardware Number: MJD6F3HW04P
Marelli Software Number: 354AB598
Fiat Identification Number: 8DF.C2
Fiat Iso Code: 68079807E3
Seen that there are... what are the numbers important? So far I've seen that are very important, the last 3 digits of the hardware and software of the ecu.. in this case 04P-page 598 ... the others are useful for what?
Greetings
Then mene happened to have some of these are of the ECU pre-step to the 8DF, but basically both HW and SW are 6F3..
if you would have other equipment for pararti your ass I would say make a Backup and then test with MPPS.. otherwise you may leave with a bitter taste in the mouth when it crashes..
354AB598 with this code in the SW know everything and don't need another
MJD6F3HW04P HW would be "Box type and Pinout of the ECU"
51872447 code replacement Fiat
8DF.C2 Identification of the vehicle and the Engine.. which in practice has the turbine above the exhaust manifold etc., "6F3 under"
68079807E3 as rightly says the word "Fiat Iso Code"
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
in the 500 mpps don't read the map, copied the ID and then searches the map ori, when you have done everything and you have to write the cuts to a mega because otherwise you cannot write
Ah here...thanks a lot...
To cut it ...I mean as they say in the guides...look for addresses where you depart from and arrive right?
to cut means the file size of 2 mega and bring it up to a 1 mega but mpps do not you write it.
it was strange that 2008 is a 8df then a 75 hp..
anyway, this ecu scrrivi easily with mpps without any problems..
we have the same machine - with the same numbers on both HW and Sw
Write permission
Quote
