Driver Lancia Lybra 2.4 jtd 001 210

[Lucif3ro]

Hi guys, as I had already? early in my presentation, I am given to do (duties apart permitting) understand how to "move" on this world. Proceed in small steps. And now I find myself "locked" into something that I can not find a solution, apart from a video on you tube that for? in my opinion ? just a small example of the procedure.
First of all, I hope to be in the right section and, eventually, I apologize in advance with the admin and the users of the forum.
But let's get to the point
Will try? to provide more? details possible. I have a dear good old lybra 2.4 jtd 2000. The "test" them to do? on her.
MPPS v12 clone and ECM2001 v6.3 are the software that I am using.
I have done a read-through MPPS, and I obtained the following information:
Bosch
1037352210

With MultiEcuScan, I have this information:
Hardware num: 0281010001
Software num: 1037352210

From there? I've learned through you, the numbers from "mark" are the last 3 digits. (001-210)
Well. I open ECM2001, but among the many available drivers, I can't find the one with the numbers above.
The question ?: At this point, what should I do? As you is able to go forward?
(I had anticipated that you would have had to have patience with me :P )
Thanks to all in advance. I hope you have a good new for me

[msport (exil77grande)]

then if you can't find a driver on the ecm with the last three digits of both the hw and the sw test to see if you can find it only with the last three digits of the sw, then the driver may be with three different initial numbers or three " x " and the second one is the last three digits 210,or try one of the drivers of the lance lbs 2.4 jtd definitely one compatible you are,or if you want to help the most concrete post the file here golds that you read that tell you which driver you need to use, as the machine is very I am sure that the driver is there.

[Lucif3ro]

msport many thanks for your helpfulness? (I note with pleasure that you are also from my hometown)
I tried all the drivers of the lybra, and in the end the one which is compatible I have found, containing as the number 3D73. The number that I find myself in the cks.
It was my first time, and fortunately it seems that everything went well

[msport (exil77grande)]

msport many thanks for your helpfulness? (I note with pleasure that you are also from my hometown)
I tried all the drivers of the lybra, and in the end the one which is compatible I have found, containing as the number 3D73. The number that I find myself in the cks.
It was my first time, and fortunately it seems that everything went well

ah you're from my hometown? well in fact, in your presentation you have left us in the middle' and maybe the complete,http://www.professionalchiptuning.ne...=9956#post9956 however, if you want a better security as I already said in the mail file ori of the machine.

[Lucif3ro]

Added the details in the presentation and file ORI annex
Lancia Lybra 2.4 jtd ORI 001-210.rar