Hi guys, as the title should I read this ecu of a lancia phedra 2.2 jtd but not from the car, but to tour with kess v2 I need help because I tried to connect it from the Pin with k-line but is not read, I followed a schema of Pin out for the plug that I have on hand if you need your provider to load the Pin out
hello, you need to remove the flash 29f400 and program it with a programmer..
remove the serial eprom 8 pin where resides the immo and try
or as well as to said matteosr unsolder the eprom and you should read it in the serial-to-tour...
perfect thanks guys, now I see or I try to desolder or I go directly on the machine to do it is that I'm going to have to do half an hour to get there!
according to me you should go and read about the car,if dissaldi the eeprom do it right away...instead of the flash 29f400 takes a little more time,then it depends on how you have expertise on soldering smd in the pcb
Yes, in fact, I thought of what I do, first go on the machine I do not have the time to desolder, and the machine serves to the end of the week then I go to them, however, I learned a new thing thanks a lot to all of you!
With the kess v2 go quiet serial. Do not desolder anything, which is always a riskOriginally Written by project
Thanks errecinque, I think like you I put hands on the welder only when strictly necessary.
these are made very well from the obd
Quote
