Hello everyone, could you give a look to this file? This is the first that I do with the plcc,, and I did the mod scopiazzando car already made saw that I was without a driver. It is a machine to test, so I can go to trial. Attached are both the files to 8bit the 2 already joined 16bit ori and mod.
They are not very practical with these with plcc, but very similar to the classic edc15
then and tasty..
I'm going to give it a little more..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
ok try so and the load on the car, let's see how it behaves, in the meantime, I thank you infinitely.
Tested machine, seems to work great, only problem, I have the light the glow plugs flashing and two dtc p1612 and p1626. In fact with the vag com, I saw that in the ecu the engine is coded 00001, that is, the automatic transmission, while it should be 00002, manual transmission. I tried to change it but I don't save the changes. How can I fix that? I have to say that I am using an ecu that was not his, but with the same numbers and scodifica total.
I read on a few forums abroad that perhaps does not save the changes because first, I have to log in with vagcom. But putting the code that I have saved from the picture, it tells me that it is wrong, I guess I have to recover it from the e2p scodificata right? If so I'm attaching the file.
Sorry don't you first copy the eprom from its original?Originally Written by amen
I would change also the SW flash if they are not equal..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Do you know why I did it? Why to play with the plcc, I have a ecu "forklift", and leave the original intact in case of any damage, otherwise I would have done so. The numbers on the ecu match all.
I don't understand the ecu the truck and to your car or other?
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
The ecu the truck is for my car, use to go in the workshop, I am attaching the e2p present at the moment on the ecu, I can not get the code
Still don't understand...
use it only for your car?
then copy the eprom from the original, and you have a ecu clone identical to all the tests that you want...
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Quote
