Lancia Phedra 2.2 128cv Problem light after programming.

[walter_ie]

Hello guys, today I wrote a Lancia Phedra 2006 2.2 128cv, I made already different and I have never had problems, but this after writing me on the triangle and on the on-board computer goes out of "anomaly system engine control". I think I have done something wrong, and then rewrite the ori. I put in motion, and immediately the light!! I try to delete with the diagnosis but nothing goes on. I've never had this thing? Does anyone know what could have happened? The auto part is good and the benefits are not limited, so do not think in lock the ecu, but the light is fixed!

[ugoboss]

hello, but diagnosis of that error do you have?

[walter_ie]

Hello, thanks for the response, however I solved. In the event you happen to someone else know that the diagnosis, at least with Delphi, not the port no DTC. I have disconnected the battery for half an hour, and the error is gone. I believe that the light is caused by the programming. However, now and ok. If you happen I recommend you disconnect the battery for half an hour and is in place!!

[claus]

have you written with ke tool ori or clone

[todos]

The guys on some of the ecus and also in the reading of the file to the eprom memory of the times goes into the lock solution, disconnect the battery and is ok, but I recommend a backup of the control unit, for nn to have problems........

[walter_ie]

I have it in writing with the rooster clone, however, say that even with official tools is success.

[Alfiuccio]

made with kess ori no problem....its going to be a "problem" but I confirm the "theory" of our friend, todos

[walter_ie]

Honestly I made already different in Phedra that Peugeot, and this is the first time that happens to me this problem. Also why is the car part and goes, it only has the lamp on, then I don't think is a real "block"

[Alfiuccio]

have you tried to disconnect the battery?

[cinqueturbo]

The encoding of the injectors and OK?