I bought one of the latest galletto 4 V54.
On the CD I can only find Fgtech edited1.0 and galletto win7.
There is no folder Fix.
Why?
The one in the plastic box instead goes without problems.
This is the party only 1 time, but with the fix.
Mprog works and gives me 1 device programmed.
While the other FIx Write EEE says interface not found.
The driver is correctly installed on win7 64bit pro.
Hello, uninstall the driver of fg from your pc and then reconnect it if it has problems, the tool will not be recognized by the pc.........then change the external boxes but hw is always the same.....
I'll try
I do not understand xchè on 2 PCS, win7 and winXp where the V53 and 54 in its plastic box to be, on this SE61-GB if I write V54.eee gives me interface not found... bho
And parito only 1 time, and in the mini-CD there are + 2 fix
At me on xp didn't want to start on win7 instead of the first installation is gone and nothing has given you the most problems.you have formatted your pc?
To me instead of on a PC to not part with some of the usb cables while the other goes without problems. On other two PC is with all the cables. Mysteries...
Having put two operating systems on xp that was on the D partition would not start,while on 7 it started without problems,but maybe that's just because it was on the C partition
You have to take some serious action.
The best according to me was the V53.
The V54 must take the product code SE61-G or -GB or VD300 in a plastic box that always starts with SE61-xx
Tested personally in the BDM on the bosch and marelli mj6df3 without any problems..
one of those and se61-6 ... and not even go to him in the bdm on edc16..... while with the v50 the law perfectly, with the 2 v54 gets me out of this error
Quote
