Mjd8f2 file 2049kb or 2048 kb

[Errecinque]

Hello I explain my problem and doubt. I have a Panda of 2011, an old body, but already with a 8f2.a visa that has already been mapped, knowing of the virtual read I downloaded a file from the database http://www.professionalchiptuning.ne...6&d=1345707541that is 2049kb. With the rooster I have read in virtual and gives me back a file to 2048kb. Now assuming that the database file is read with kess (I also own one) that has the ability to separate the files in the micro and the flash, what should I do? That is, if I want to write with rooster ok I edit the file directly by 2048, and I write, I think, while with kess as to be written? I have to separate and then get together to write or I can write the flash without touching the micro ?Thanks

[Errecinque]

Ah, and then I'll ask you since I have never written this.... It is better to line the can or K line?

[ugoboss]

I don't think that the panda can do it in the can, I read really (no virtual) with the kess and the made the k-line and the file and 2048kb, my advice and read it really, then you do what you have to do the rewrite, working on the read file directly.

[Errecinque]

The.file the injectors read on the can (this is the only way you have the tools available) , but then it has not done me the ecu id gave me a hw error, and the output I selected auto-6f3....bohh

[dragusdrake]

the right file is 2048, if the cemtralina is not communicating on the can, you have to farlaùin kline tranquillamwnte

[Andrea1]

Aside from the speech, kline can be seen that I have already answered exactly dragus, I have done a punto evo with a 8f2 read with kess and the file was 2048 KB...
If it's the first read/write with kess will ask you to press the clutch and start the engine before completing the read/write with the cock, I don't know why I never tried.

[dragusdrake]

it is correct, is used to recode the sensor on the clutch pedal, the cock-of-date does the mj8

[Errecinque]

I caught surely a hybrid ecu because on kess the engine code does not match the booklet, there is under mjd8. Tomorrow I'll put more data in, so that you can advise me better. Then the file from 2049 is read in jtag?

[Andrea1]

I've never made a 8f2 a tour so I could not tell you with accuracy, for curiosity I downloaded the file and tried to open it with the ecm and I recognize a driver and then the file on the database I believe is correct.

[Errecinque]

This to me is recognizes this and also recognizes that by 2048 the bed in virtual cock with the same driver, but if you have loads for comparison tells you that you must align the x different sizes. Does anyone know how to cut by 2049 and 2048?