Reset the ecu EDC17C46 VAG for partial write

[aurelioweb]

Hi guys even I have written that already? you got practically everything ? started this morning when I ? got the map to load with the cock 54, but I don't make them do the checksum of the program, look for it to finish to write as I had recommended the mapper and rewrite the map this time making the checksum to him (putting in about 5 minutes only for the calculation) qu? ok, I'm going drive the horsemanship and not v? in motion then pensand is problem of wrong checksum I decide to replace the original file to see if I was right, and I choose the right file and start writing, and now well-known that, do not ask me to calculate the checksum, but we do not do the case even why? she immediately started writing gets to 17% and them crashes iniziandomi to say to turn on and turn off the ignition, I did, but the second time I d? error and closes the connection, and from that moment I can not pi? connect always tells me to switch on and switch off the ignition and to the second connection I d? error; ? can restore it or do I have to procurane another scodificandola? I wanted to ask as well, would it be possible to clone my using only the 3 files of the complete reading that I was able to read? Thanks a lot for the help that you give me

[tecnoecu]

sorry, but if you have the bekup write to tour see ke solve.

[aurelioweb]

I do not have BDM otherwise I would have already? done and Galletto clone BDM: I have not recommended

[sno74]

But these need to be written and read in Boot Mode, not in serial if you have the v54 the CKS only if ? connected to the network and ori.....

[aurelioweb]

so even if you asking me really doesn't do that, and then leave the one that was there

[rodcraft86]

the ktag does it all without a hitch, take the file and edit it with titanium, save it with the cecksum that corrects titanium, and write this without it correct to gallo, should go

[oakley1]

First of all... ? was open to load the first map??? A similar thing ? happened to me with a c46... I Think due to damage to the opening... before you have just written was in the bike with some damage.. Then ? going well... Then again failure... Then the same movie of your writing... Try to shoot it all up... Otherwise ? you want to replace.

[ugoboss]

I sincerely did not understand how ? been read and written to this unit, you made it to the tour in bootmode or serial.

[aurelioweb]

Then guys ? been read and written in bootmode the problem ? born when I went to load the original map the second time since then, even makes me load the data processor, the cock always tells me to turn on and off the picture already? from the connection stage

[oakley1]

Let's see.... If the mountains in the car and try to get in diagnosis that error from? U0100 for the case?