Shaking engine golf

[panterargento]

Hello, today I've pulled already? a map from a golf 5 2.0 140cv, this ? was made, as it says in the owner, by a well-known trainer in my area (of which I do not trust), however I do not feel able to judge the map as a test and studies, I have facts on my edc16c39, on these ecu I only limited to close the egr and departures to the hot (read in the forum)...
However, the guy says to be satisfied, except for the problem, in fact, that I'm about to describe to you.
In practice, the car I tested, the effects in relation to the performance does not seem to bad, but the fact is that when ? stop in motion, every 2-3 seconds, you will hear gasps, in practice, is the right of the movements of ground shaking that are not exaggerated for? feel.
Sincerely given my lack of experience, looking at the map I don't understand where the problem could be and I entrust myself to you in case you found the cause.
Thank you in advance.
I forgot...the well-known trainer told him that ****llo of the map there are no solutions and that the problem can? be due to some injector that is ? perfectly calibrated, (I honestly do not believe it, why? I wrote the ori, and the machine is not the problem), however this ? what I ? was reported and that you will carry.

Golf V 2.0 140cv
EDC16U1
03G906016ET
0281011843
1037370224

[passione motori]

Hello, these cars suffer from the defect in wiring harness has hot looks + frequently, try to put the file ori and use the car for a few days....

[panterargento]

Hello, in the meantime, thanks for the reply, but putting the file ori and turning for a few miles, the proplema disappears...so ? to exclude that you can place something on the map?

[carlo abarth]

at the dealer if the car has no engine problems as the flywheel and injectors....and excluding the map that I have yet to receive did update soft !!!

[passione motori]

Hello, in the meantime, thanks for the reply, but putting the file ori and turning for a few miles, the proplema disappears...so ? to exclude that you can place something on the map?

Not just a few kilometers, just take several days only then you can make exclusion map

[panterargento]

Ok we will do this test.

[claudio-abarth]

also, the engine of the car my brother shaking,we have changed the engine mount on the gearbox side and the problem ? gone....

[RTR]

I did not understand well the problem, but if the car shakes at idle I can't see what preparer, as such, should be to touch that area...even if, unfortunately, if they see raw and cooked

[panterargento]

also, the engine of the car my brother shaking,we have changed the engine mount on the gearbox side and the problem ? gone....

The fact ? that is just to hot, I think that if it was the support he had to do even in the cold...I doubt it's that but not ? you want to exclude.

I did not understand well the problem, but if the car shakes at idle I can't see what preparer, as such, should be to touch that area...even if, unfortunately, if they see raw and cooked

I don't know honestly, if someone has seen the map might judge, I don't think I can find the problem in the map, maybe the place to be in a different discussion to have an opinion, but more? that performance I'm interested in if c'? some increase that is causing the problem...

[audi a3]

hello, I want advice before you do, check the distribution read this link http://forum.audirsclub.it/showthrea...per-motore-BKD

let me know hello