Hi guys I ask for help to all of you for this problem..I recently purchased an audi a3 2.0 tdi BMM and I immediately noticed that you deleted the fap from the old owner..after a bit of miles known to occasionally at least 2 times a week as it comes up to temperature the car goes into protection and not go the more revs like a naturally aspirated..I then tried to do a scan with vag but the best, and that not from any error in memory, and just switch it off and power back up the machine, or just that the gate errors even if you are not there and the drive back affixed.... I read the file with mpps and I hope that someone of good heart, I can advise you or check if in the file there are some error ....p.s. I noticed by the parameters of the two temperature sensors of fap measure all and -276 degrees and normal-?
thanks in advance
That file was done with the walk, and together with the fap, that usually makes clearing a single bit, were leveled a lot of things, including the errors table, so you have problems that are not detected in the diagnosis. It seems to me as much a work of Ecusafe
That said tap to start from scratch with the original file and reset the individual bits of the fap, without touching anything. The speech of the temperatures is right with the dpf off.
Thanks blakwolf for your availability and your response ..then I affidero to some trainer to get me to make a file with the luca stanca right ...but in my mind I was thinking ..may be it was the fact the luca stanca with some active regeneration or errors in the ecu, and that's why I create this problem ?
try with this file and see how it goes... in case you still have problems contact me on my **** that is my nick followed by the suffix ***** and we try to understand besides...
Quote
