Help scodifica Alfa 145 1.4 16v ecu bosch m 1.5.5

[tecnoservizi]

Hi guys, I am struggling with a alfa 145 1,4 ts 16v 2000 will not start, not even with the procedure emrgenza, I have the code and the master key,
I would like to scodificare the control unit.
these are the numbers on the ecu
0 261 204 943
0 36 b
00467754110
Can I do it with file bcb and galletto 1260 in the boot?
Do I need to open the ecu and ground the point near to the eeprom? Do you think I feel or ruin the ecu?
Thanks

[stefano261168]

I, or did it several times and the first or ruined because when I was in the procedure of ground near to the eeprom I was moving and tear those little strands next to the eeprom .or started to stop to give a hand to another person

[scinti]

The Ecu is a bit tricky, you can only write it, and with the dedicated file, otherwise it crashes

[tecnoservizi]

Thanks for the replies, I found the two files to be written in bcb. Now tomorrow I will explain to you well that file are.
In fact, not being able to read the unique and write the right files, but I can also do a tour, according to you, hello

[cinqueturbo]

Thanks for the replies, I found the two files to be written in bcb. Now tomorrow I will explain to you well that file are.
In fact, not being able to read the unique and write the right files, but I can also do a tour, according to you, hello

Why did you think you could do in the OBD?

[tecnoservizi]

No I meant with the ecu removed. The problem is the difference in files between vergin ecu and scodifica total I do not understand how to get to scodifica total, since the ones I have are a named cod 156.bcb and the other f3791 mod.bcb, to write before the cod files, and then the mod, or am I wrong according to you? Unfortunately, around this ecu there are multiple indications in the network, and many refer to the ecu mounted and with code recognized, I rather would I need to scodificarla even if it does not recognize the code, if someone is so kind to let me know the correct procedure, thanks

[tecnoservizi]

m155.raralfa%20155%20boot%20help.JPG

These are the files .I have no way of reading them, and given that even the ecu can read, the only would be to find a file ori with steeso sw and hw, and from there do the scodifica.
From what I understand the boot scoperchia the ecu, it puts a mass point close to 24c and then for 3 seconds, the pin 10 to 12v, in addition to other links, and mass galletto, ecu common confirmed?