147 jtd edc15c7 start!

[artone]

Then I read the original file of my car to tel a 147jtd 115 hp with ecu 15c7 below the original file:
file ori deleted

for now I just want to understand the process and I edited the file with ECM Titanium to linearize the system, the modified file ? the following:
147-488-ORI_linearizzazione debimetro.zip

This last file if I open with ECM, I show the change properly after for? you have chosen to hand the driver.
I compared the two files with the utility of the ecm are different but have the same checksum 009.

I don ? clear if I can rewrite the file cos? com' ? with EOBD2 or if I should do the other steps...who is giving me a hand ?

the next step in this will be:
1) EGR
2), a light mapping

Thanks in advance

A admin if it can? correct me 157 147...thanks

[leandro89]

Then I read the original file of my car to tel a 147jtd 115 hp with ecu 15c7 below the original file:
file ori deleted

for now I just want to understand the process and I edited the file with ECM Titanium to linearize the system, the modified file ? the following:
147-488-ORI_linearizzazione debimetro.zip

This last file if I open with ECM, I show the change properly after for? you have chosen to hand the driver.
I compared the two files with the utility of the ecm are different but have the same checksum 009.

I don ? clear if I can rewrite the file cos? com' ? with EOBD2 or if I should do the other steps...who is giving me a hand ?

the next step in this will be:
1) EGR
2), a light mapping

Thanks in advance

A admin if it can? correct me 157 147...thanks

the file ori should be inserted in the database if there were, and in the discussion it must be pasted the link with the number of posts

[artone]

? gi? in the database
thanks for the correction
hello

[biondo83]

The checksum is calculated automatically from your serial programmer in the process of writing.

[nox]

But I do not think that if you are using the gall to write the correct the cks automatically cks is corrected automatically by edc16 ! On edc 15 I fix this before writing if you use mpps or hardware that allow you to or with ecm titanium if you have the driver. Once you save the mod file you correct him

[artone]

...read using the gallo...
in the documentation of the ecm ? reported that if the driver ? this the cecksum ? calculated automatically

then scivo simply the file .MOD exported from the ECM???

[sportknight]

the ecm will find the driver?
if you find that when you save the file you must save the checksum is different!!

[artone]

I find that when I read the original file...it is two to tell the truth : 15c7 488 and 490 15c7

then when I open the file .mod does not find it, but I have to specify it I ...so?

[biondo83]

On the EDC15c the checksum you automatically calculates your programmer Galletto serial OBD.
Tested several times.

Probably the software of management of my interface Galletto, the calcoler? in automatic. :-/

[artone]

On the EDC15c the checksum you automatically calculates your programmer Galletto serial OBD.
Tested several times.

so I can flash my file .Mod directly ?