read ford fiesta 1.4 68cv with cock

[igor]

good evening to all, I came across a ford fiesta 1.4 68cv with ecu siemens sid 804 and I wanted to download it with the cock 1260, but I knew that I had to ground the pin 28 (if I remember correctly) of the flasheprom and I have a p? scared then, after you open the unit and locate the pin (why? the curiosity? has taken over ), I stopped for fear of any damage, any of you could kindly tell me if I can trust you to download it with this procedure??? and in the case in which damages can I run???
thank you in advance

[FidodidoTuning]

let siemens is that the blocks
change hw

[msport (exil77grande)]

I would also say that I do not do it with the old cock take a magpro or a rooster v2 and go quiet also because with the pin to ground in the past someone has burned the ecu.

[igor]

thanks a lot, could you tell me how can I download it without the bdm? I have only galletto 1260 and mpps v12
are always pi? convinced to invest in these blessed 400 and broken

do at least I can make my beloved scania truks

[carlo abarth]

go with the magpro I made a 10ina and go well !!!

[igor]

but if the old cock block because they themselves are the ones to tell you to do so, and you put so much of schema

[nuovaecu]

I confirm that I do not do it with the old cock I burned bad I had to repair from a fellow bad experience

[mafani]

I would also say that I do not do it with the old cock take a magpro or a rooster v2 and go quiet also because with the pin to ground in the past someone has burned the ecu.

listen msport in the past, I was at the beginning too, I have made one with the old cock and luckily went' all is well

[jolidj]

nn if you have the mag then remove and read only the flash , edit ,write and balances , nn risk nothing.

[magi1984]

I've made it with the cock 2 without problems