Mag pro error step n: 37 EDC16

[hackgen]

Hi guys,
I found a problem in the reading and in the writing of the maps through the serial port with mag pro v 4,
the machine ? a audi a4 140 of 2007 during the reading of the information of the control unit,
the program gives me the following error:

The ecu is Locked, unable to continue programming,"Error - Step n: 37".

We mapped the machine several times with both mag that with mpps any problems,
do you have a solution to part of the bdm?

For case, there is a counter that stops the unit if it is written with a defined number of times?

Thanks to early

[giarras]

try to disconnect the battery x is a p?, that to me is there are no limits to writing.

[hackgen]

Ok, I test it and place the result !! Thanks

[hackgen]

Mhhh, nothing to do test failed !! Other suggestions?

[sportknight]

you get error already? in the process of reading?

try to stick a charger

[hackgen]

It gives me error already? in the process of reading, as if there was something that stopped me ? for? had a doubt, this defect if I'm not mistaken ? out of it from when I changed the key, I would not be the encoding of the key tonight I try with the spare key.
The battery I scored 12.6

Other tests?

[frantik3]

spent some time with ecusafe

[hackgen]

the ninth ever spent

[eismann]

but you nail the ecu?? where you the one with the network connector or the other?? check the cables! and check the welds internal!

[hackgen]

In That sense, I nail the ecu? read some information and then gives me that error. I have the one with the serial cables are perfect with the other machines work.

but you nail the ecu?? where you the one with the network connector or the other?? check the cables! and check the welds internal!