problem unit multijet

[crteam]

hi friends I have a problem on a fiat doblo 1.3 nevertheless, with the control unit marelli 6f3 d4 and insight into the processor.now I have a question for you if you can help me I found a ecu 6f3 of the fiat idea, according to you, could be mounted?has anyone tried already?and a 6f3 m3.appearance answers thanks a lot

the control unit dobl? NEVERTHELESS, 6F3.D4/HW03R/3056-D446 DOBLO CHALLENGES EU4 75HP CARGO 5T9-37R7G unit idea NEVERTHELESS, 6F3.M3/HW03T/3056-M350 IDEA 1.3 SDE EU4 90HP UEGO 5TSSHJ77G thanks

[obd75]

if c'? someone with direct experience you can? to say something of course,
I this week on g.the point,then a different system,I did the test to pass an ecu and use the code to start the emergency,as a result I have not had the insertion of the motors of the avv.
the test pi? certain ? scodificare partial and you have all the answers.

[legendaryslave]

copy all the backup of the ecu should normally go to the marelli are copied to the 100 percent

[crteam]

the mpc and split if no was applied...

[mafani]

try to ask if someone has a reading bdm of the same hw and sw, and you use only the e2p of your track

[jolidj]

falla virgin to the new and the mountains.

[tt225]

If it can? be of interest to you I have a reading with FGTECH official MPC + FLASH

Excuse, I forgot to read from the Obd, however, complete

[crteam]

you send but and the same van doblo?the same ecu?

guys kiedo excuse someone has a pinout of the bdm of these units?for the rooster?the e xxx nn I see him so for which I wanted to compare it to, or if someone kindly can? post the photo.in the documents nn ec the detailed diagram

[tt225]

It means the same ecu with what you are going to write ?
FIAT DOBLO 1.3 MJD6F3HW03R 3056D446 51784560

I ask you, why? if you write BDM you will need to adjust the length of the MPC

Here it is

[crteam]

Here it is

Annex 4631

send me via *****?
I don't think it is possible to open here...what do you mean by adjusting the length???