bmw and 90 error 3ff1

[nerone]

hi guys. I have a problem with a bmw 320 d e90 2005 with 120kw. made a diagnosis and I have an error relative to the air mass meter with the code 3ff1. sobbed to a minimum, not always, and then goes and then comes back. in the street equally, hiccups and loss of power with fumosit? black,then goes and then comes back. I noticed that if out the meter the hiccup goes away and comes back just rejoin the spinet.I also noticed that ? dirty engine oil and I checked out the game of the turbine, a bit of play in the wheel, but looking at the impeller, it all seems intact. one other thing, I noticed that stays the regulator of the geometry even with the engine off and the picture off, for at least a quarter of an hour. you know me some advice. thanks in advance

[legendaryslave]

look at the mass of air sucked in and objective, as are the values in the diagnosis ,but the hiccups I think drivi from the egr test to take a ride with a sheet or try to close the egr from the engine ecu

[nerone]

my tool of diagnosis nn I from these parameters... only on the sensor, absolute pressure and pressure turbocharger. seguir? your board,begin to eliminate the egr

hi guys. I was able to make a diagnosis with a check star marelli . the mass air flow sensor seems to measure well, for? this tool gives me another error code p3264,I think it is related to the fap or something. that you advise me

[infinityecu]

it could be I of the sensor rail or sovraalimentazione

[sportknight]

probably ? the egr..

[nerone]

thanks, tonight I try to exclude it

[nerone]

hi to all , then thank you all for the advice . the egr check and excluded but always the same, the sensor rail ok, not ? not even that. I did a diagnosis with texa idc4 . 2 errors. 3f35 pipe turbocharger,monitoring at a minimum,the error present.
3ff1 air mass meter,the error present.
which would you recommend for me? I replace the mass air flow sensor?

[Gia]

It parts from the mass air flow sensor! Penei is damaged by oil. May be caused by excessive engine ventilation, also it can? be caused by pdf clogged, swirl clogged, etc... Hopefully I explained to you the road to follow

[nerone]

thank you very much dear.. I wanted to confirm.. will change also unit? vent even if the game is that the turbine does not like it at all... again thanks a lot

[Gia]

thank you very much dear.. I wanted to confirm.. will change also unit? vent even if the game is that the turbine does not like it at all... again thanks a lot

Proceed one step at a time