Hi I have a problem with this car, it will not charge the pressure to the starter. Charge approximately 6 bar, pump and injectors have been tested for a tour up to 1650 bar and they are ok. The car in the trailer, but does not hold the minimum.
Hi I have a problem with this car, it will not charge the pressure to the starter. Charge approximately 6 bar, pump and injectors have been tested for a tour up to 1650 bar and they are ok. The car in the trailer, but does not hold the minimum.
check any rel? or me figured out once and was gone a capacitor internal to the ecu
there is a loss of pressure I ricontrollerei the injectors!!
that pump mount this drive....
must be a delphi...with ecu siemens..check the pump pressure and low pressure....must give 2.5 to 4 bar...
A rider does not create queues even in the car...
a automoblista create queues even on a motorcycle...
Trivial question... but ? the type with sensor phase on the pump pulley?? If you do not align, even one not part.
? for this you need to know that the pump mounts to see if it has the pump low diagnosis what you have faults you see pressure on the rail as read in the start-up phase.........
On the pump it says continental k05_04, the ecu is a sid 305...
I repeat, the pump and the injectors were tested on 2 different banks is mounted with the caps and digital pressure gauge...the maximum charge 6-7 bar also from diagnosis! Of course, no diagnosis from nothing!
not ? in a case like this ? the engine that has problems, type-a valve cylinder head that will not close???
Misuragli compression...
Write permission
Quote