Good morning...who knows I would like a little elucidation. Quest car is not starting....error p0089....stuff pressure rail....in short, I realized that after the high pressure pump does not come out of diesel to power the flute.....I tried to change the regulator but nada....someone has dimistichezza? Thanks
I forgot that the pump l I-powered car with a blower....therefore, excluding the filter and the draft....
you asked a question and given yourself the answer. is the pump HP, which does not work, you need to replace it or repair it..
Quoto what you say, but.....in the absence of signal on the controller I could have the same problem?
hello riox
what was the defect? from nothing, or after some work? the map ori or mod?
switch to inertial? immobiliser?
pressure sensor 3pin: 1 in mass 1 receives 5V from the ecu 1 variable voltage "to" ecu about 0.5 volts with ignition on/engine off and increasing the aumerntare rpm... I'd say so-of-thumb 1.5 V during start-up if the pressures are in place
for the sake controllatina sensor and/or sensor phase
as you have seen, ZERO-discharge the hp?
Surely you have to have voltage on the regulator. I don't know the voltage to get them, but measure as you spin and try the starter, if 0 voltage, check the things I said aboveOriginally Written by riox80
When I get the time to test if the signal....will update...thanks to all of you..***** s, the only dtc is the pressure regulator diesel of course....he is alarmed because the sensor rail is not detected pressure.
Hi are you sure that there is' a bubble of air filter clogged or fuel is bad ,or injectors blocked.
I forgot to update....was the pump hp...
For LIGHTNING..before interacting please read all of The comments...
A dear friend of that arrogance
Quote
