V54 boot edc15c7 stilo

[DavideO]

Hello everyone! Yesterday having a edc15c7 a stylus I decided to try to read it at the bench with galletto v54. Then I opened it I connected a 12v power supply pin 4 and 58 negative pin 1 Kline (the rooster calls iniection)pin 48 and the wire boot, grey, l I attached to the pin 24 of the flash. I selected Bosch 1 Micro flash 400 boot mode c167. The boot wouldn't start I tried in all the ways. At the end, almost by chance I tried unplugging the charger and riattaccandolo to the place of use-l switch and it worked read and written without problems and without desoldering anything.

[DavideO]

20160322_153703.jpg here's the photo of the connection to pin 24. I tried to open the plug and the switch does not remove power l is for the one that was wrong

[aleg]

But edc 15 does not have the boot

[DavideO]

If you do not connect pin 24 nn the laws because it remains active in the code if not I have also read that you can desolder the e2p on the back, but so is the first

[cinqueturbo]

If you do not connect pin 24 nn the laws because it remains active in the code if not I have also read that you can desolder the e2p on the back, but so is the first

In fact, some tools are not able to inhibit the immo in the boot and you need to desolder the e2prom..
if you are equipped and have the skills dissaldala and retry the read...

[DavideO]

I opened the post so if it were to happen to someone is nn could with the cock, can try to check the switch which in my case is that not being attached to the positive coming from the power supply was starting the boot! Certainly not r5 so it is a unit to practice, now I made account to buy a soldering station and do some testing! I was wondering if the ecu of the stilo scodificata can start a 147 just to see if it goes..

[rego88]

I read to counter those units, dissaldo always e2p, in a moment but even this solution is not bad at all.....

[dadal]

Hello everyone! Yesterday having a edc15c7 a stylus I decided to try to read it at the bench with galletto v54. Then I opened it I connected a 12v power supply pin 4 and 58 negative pin 1 Kline (the rooster calls iniection)pin 48 and the wire boot, grey, l I attached to the pin 24 of the flash. I selected Bosch 1 Micro flash 400 boot mode c167. The boot wouldn't start I tried in all the ways. At the end, almost by chance I tried unplugging the charger and riattaccandolo to the place of use-l switch and it worked read and written without problems and without desoldering anything.

i confirm that it works good