cloning sid 804

[tecnoecu]

hi guys I am writing because I have a problem with ecu sid-804, mounted on a citroen c2, in practice, should I also clone this ecu with a socket to collapse with the same number hw I copied the 29f400bb and tried, but I agree with the part you know tell me what do I do?as equipment I have ktag kess v2 and gq4x orig.thanks in advance to all

[cinqueturbo]

You copied only the Flash..
the eprom?

[tecnoecu]

hello nn I copied because it's usually for scodificare part of this type of ecu I just need the data flash.this if I'm not mistaken, the eeprom on the door from the opposite side to the processor right?

[sportknight]

yes, but the data of the bsi ce them in the eprom then you'll need to copy the eprom

[tecnoecu]

ok I try and I want to know

[legendaryslave]

raises capacitors is the under

[amen]

Don't be afraid to break the connections of the capacitors, bend until you memory easy to desolder, it does not break anything, just two supportini of plastic, then when you put the capacitors in their place will come back all ok.

[legendaryslave]

Don't be afraid to break the connections of the capacitors, bend until you memory easy to desolder, it does not break anything, just two supportini of plastic, then when you put the capacitors in their place will come back all ok.

Up to a certain point, however, that by raising the capacitors and bend the pcb and then always with due policy

[tecnoecu]

then I copied the data from either eeprom or flash, but it was the machine nn part I repeat I have them copied on a ecu with the same nm hw

[amen]

Then must necessarily start, you enter the diagnosis?