Before reading explanations!

[project]

Hi guys, I have finally started with the practice!
As the first reading I performed a reading in jtag a marelli 8GMF.A5 a mito 1.4 Mair turbo 170cv, the reading went well with a galletto V54.
now if possible I would like to have qualcge elucidation namely on what I have read.
I did the full read of the ecu and has saved me 3 files, one named .all one eeprom, and one that I don't remember.
I would like to know what are those three files for which reason I save 3.
then the wing nut I have the opportunity to read individually the Flash, micro and eeprom what is l and what l atra taken individually?
on that .all I've seen that I can open to go to work on the map.

[overbooster]

flash=motor data
micro=data processor
eeprom=encodings(keys,frame,...)

[project]

Thanks overbooster!
so as to operate on the map,egr,fap and anything else I should work on flash
immo,scodifiche on the eeprom.
and to perform the works of scodifica immo,luca stanca and delete the egr you can also do manually without the use of software that do the job?
what?

[overbooster]

If you know what to do you do them by hand or need here on the forum which you can find many guides for software in the Home you will find the whole list

[project]

thanks a lot!!

[project]

I tried and delete the oxygen sensor with time, now if I want to try to check whether the software has done a good job how should I do?

[overbooster]

compare the mod file with the ori, and see if you have changes

[project]

with ECM titanium? because with ecm titanium I tried to compare,I opened the 2d graphics but it seems that they are the same even the wording changed, writes no

[overbooster]

It may be that it has not changed anything...

[project]

load the file ori and mod file. lambdaoff on the map I have not seen changes the only thing I found different is the checksum, is it possible?