clone the ecu FIAT PUNTO EVO 1.3 75HP MARELLI MJD8F3.GG
Good morning to all
I would like to make a clone of this unit
Marelli MJD8F.GG
HW1FL 2841-GG44
55255946
in order to avoid making unnecessary purchases could someone kindly explain to me what the acronyms I have to take into account to be sure that it is compatible?
Thanks to all
GIANNI
hardware MJD8F.GG HW1FL
software 2841-GG44
number fiat 55255946
if you use the sw that you have already you need a controller with hw equal.
ugo ---- president A.E.P.
Thanks a lot
Friendly
Sorry
is that the ecu is only possible to read it in the BDM ?
however, it is written, even in the OBD'?
Thanks again
GIANNI
Not in the BDM, but in J-dag..Originally Written by gianni1001
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
ah ok ,I've never done it in that mode
and it's particularly annoying to open and read, or it is in the standard?
if you have any recommendations are welcome
Thanks
GIANNI
Na rongia!!ah ok ,I've never done it in that mode
and it's particularly annoying to open and read, or it is in the standard?
if you have any recommendations are welcome
Thanks
to open it, open it,
but to dismiss it as before I do not think it is possible...
reading and writing is always dependent on your tool..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Write permission
Quote
