But on these old eprom 27c128DIL from 16kb, after mapping we need to do the checksum or not ?
I ask because I have to make a map of this ORI but I don't have the checksum calculator for these.
If you need to do the checksum, there is qualchuno that' knows' or can it be done?
Thanks in advance!
si c'? to do the check.... if you don't, it seems to me that it starts the same machine...
perhaps you have left a light on...
anyway, a programming sw ECM type, etc.. they do it automatically
Thanks for the response, however, the ECM does not' automatically because it does not have is' the family of checksum, and don't even MAP 3D and certainly' the old checksum calculator.
Thanks the same!
The cecksum you directly calculates the software with which you write the eeprom, or there is a similar function on the inside, with what the read and write??
The patience and virtue of the strong..
edit the file...
write it down...
and test...
you will see that there will be? no problem...
Ok, thanks a lot, I'll try so then I'll keep you informed as and andatta... Thanks!Originally Written by alfajtd
you don't need to cecksum
discussion moved to section ir? fit, do more? attention the next time
You excuse, I was wrong to post it, but I also subbito alone reported that' I did it...
Back wing question, I can conffermare what they said alfajtd and frantik3 (thank you!), because today I uploaded the file without calculating the checksum and the machine, and the game, with no problems.
Thread closed for me, thanks also to the others that I have above cittato and have intervened.
do you hand ,if you want, but on these the problem ? the chsum , 280 horsepower possible all golds but to tour with stecchio . better if you use 100-octane fuel
if you want info on delta , I have all what you want, I was running up until a few years ago
Write permission
Quote