Hello to all of you for working with some of the units in the template and schedule are critical, or are only to simplify the work of the k-tag?
documenting I understand that those accessories allow you to not have to stay in the doldrums of the pins on the doors ecu I say right?
what is the difference between pin and pin spring?
to simplify the work
you say right
to make things easier and make a cleaner, schedule the spring-support them and you're right, the legs normal you have to get them welded.
ugo ---- president A.E.P.
but even the feet normal if there's one is the only one,for example, the boot is not convenient to use the tip and appoggiarcelo instead of solder?
Ok thanks ugoboss now it is clear to me 100%.
I bought the ktag about a month ago (but no, I have not yet used). from the site where I got it, I did not see the legs in the spring then I purchased only the schedule.
yesterday, after reading your response,I searched for other sites that specialize in these pins... but it is possible that cost from 5 to 10€ the one??? or are not the ones that I have seen those that we intend ?
then I ask about the ferrule with the cable fine blue ce you can connect the jack to the out jack of kess:
it serves to give the boot mode poggiandolo on the pin of the flash? or need anything else?
I did the same to your question,I think you can use it for that as well
Write permission
Quote
