Fap grande punto 1.3 75hp regeneration without any warning on the framework

[easyalbert]

Hi all, I have tried in the removal of a Fap in a Great point about using the ecu...fe and I noticed that the machine after a p? it goes into regeneration without any warning light on the dashboard, can inhibit signaling only on the dashboard?

[msport (exil77grande)]

hello,ecusafe does not work on that vehicle then you have to go to someone who knows how to do it manually if you need, we are available.

[easyalbert]

Ok, as I thought from the data in the diagnosis, does not work....at least now I have confirmation...as regards the management of the turbo on this car ? electronic pierburg, has anyone tried to translate the same system on a 75 with management fully mechanical pressure? According to me for linearity? you should be able to do without too many problems having an overboost right where we need it..

[leandro89]

the light on the filter is clogged you check that, if c'? a blockage excessive, but if ? programmed do not necessarily have to tick the lamp

[easyalbert]

It is, in fact, I agree with what you just said...and also there ? also that a certain number of miles, especially on the 500 mjet which in theory should determine the degradation of the oil and the eventual replacement.....

[leandro89]

Perhaps if the diagnosis perform the replacement filter leading to clogging to zero, and see what happens. However, I know some things need to be modified manually to remove the regenerations programmed.

[luigigtc]

to delete the fap I know that before you f? physically and then electronically, please contact a trainer expert

[explode82]

as all of the 1.3 mjt there are things that have to be made necessarily by hand in anyway ? a good rule to follow certain procedures before removing the electronics

[msport (exil77grande)]

the work remember that you are always the first electronically and then physically.

[frantik3]

as all of the 1.3 mjt there are things that have to be made necessarily by hand in anyway ? a good rule to follow certain procedures before removing the electronics

the exact and the procedure to be done before writing this

Procedure:

1 Connect the diagnosis, and with the motor a >70 degrees make the replacement of the FAP to bring the ashes to zero
If between actions/activations not c'? the replacement of the FAP do a forced regeneration

2. Check the list of parameters that the ashes are set to zero

3 Write the modified file