As the title I should scodificare this ecu in partial or in total, I would ask the experts after gi? read other posts ,if immo decoding for the total goes well and if the ecu can read it or just write it thanks
As the title I should scodificare this ecu in partial or in total, I would ask the experts after gi? read other posts ,if immo decoding for the total goes well and if the ecu can read it or just write it thanks
Also interested in a m?..
or ME1.5.5 GM and non-or even tried to read it, why? or doubt on the pin out..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
you can only write to a file without immo
the me1.5.5 gm ? different from m1.5.5 fiat and the pinout ? differentOriginally Written by cinqueturbo
attention to the me of the fiat group to be made in the boot with good equipment
If you are never wrong means you're not solving a really difficult problem. This is a serious mistake
I ask too much, since I've heard bad both of the telephone that...........x-a file already tested thanks
For case, can you help me with the pinout?
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
hello glittering chiffon party dress.fitted what tool did you read it? we read in the boot, it depends on whether your instrument lets him do. I suggest if you can do a reading with your tool, have it with an editor and compare it with the file that gives you the immodecoding
Connect your programmer to the K line, as in the picture to the left and then with the tip shunting the point shown in the photo to the right.
I mpps v 5. gallo v, 48 and 53 thanks to all
Write permission
Quote