Help fix km Lancia Y

[ecutano]

Raga hello , I need help for the correction of the kilometers of this Lancia Y 2006 , I processed the file with Ny04 , but apparently the program corrects it but when I connect the framework to the car, I have a mileage different and also the service is expired , do I need to bring the kilometers about 74234 KM and the service 63267km with a date in about 10 months, f? thanks for the help.

PS

On NY04 the eprom is 93c66, but the instrument panel is mounted on a 93s66.

[obd75]

the test ....

[ecutano]

the test ....

Unfortunately, it's not okay , I don't understand the house is the success of this framework , I have tried several times to program the 93s66 with different mileages, but nothing continues to display distances different from those desired.

Any idea ??

[obd75]

but of that order are the differences?
you could do the test to reset the value odometrico and take it forward with the diagnosis,not s? if it works, too, for the other values.
I breenbee and allows me to make changes in both the s? that in gi? and for all the functions (service,date,km last service is not s? if other do the same.
however, your ? an anomalous case,not me ? ever happened to you.

[ecutano]

but of that order are the differences?
you could do the test to reset the value odometrico and take it forward with the diagnosis,not s? if it works, too, for the other values.
I breenbee and allows me to make changes in both the s? that in gi? and for all the functions (service,date,km last service is not s? if other do the same.
however, your ? an anomalous case,not me ? ever happened to you.

I tried to reset the miles , it continues to show about 125xxx km , however the first time that I had corrected the miles to the first ignition I had the exact mileage written , but the service , which I had correct , I could not reset it with the diagnostic tool , so I decided to fix the value of the service through ny04 , and here, after the replacement I started having problems , km that do not correspond to those desired, and service can't be zeroed , the only thing that I did not go back ? that Ny04 process the file as a 93c66 while the tool mounts 93s66 , for the rest I have not encountered difficulty , however at this point I doubt that it is a problem to 93s66 even why? looking back at the steps taken after a programming of the 93s66 I had done a re-reading and comparing the file written with the one bed I had made of the differences.
For the use, by the UPA and Ny04

[obd75]

there's nothing that advise you to replace the 93xx. I repeat anomalous case,I've done paintings with s66 and used nyo4.
according to m? you can put a c66...