Problem hot air 500 abarth hatch mixer tap hot cold route

[oakley1]

Hello as the title suggests I write to ask you this question. My 500 ? plagued by this problem and the circle? some pious soul, which resolved without changing all the stove but only repairing the door. Maybe if someone has the exploded view of where is this door, it would be appreciated. Thanks. Oakley

[enzopezzano]

the paddle of the mixer and the inside of the package of the heater, behind the dashboard. Then sonta ari bag,odometer,radio,heating controls,steering wheel, etc..... remove the whole dashboard after which? after downloading the installation of air conditioning and disengaged, hardware pack, warming up in the engine compartment, the dismount from the vehicle's interior and then you have to open. Good fun. Drew ,if you're a patient let loose and leak, do by another.

[oakley1]

Hi thanks for the reply...I wanted to know if ? the only solution apart from leave it cos?.... You can't? see the door from below, for example.? Do not even know where ? located near the fan or elsewhere

[Backgroop]

the problem is in the gears that open and close the door of the mixer, it happens that you are broken and I don't know if you can? access by removing the drawer, door objects, otherwise you should remove the plangia dashboard and verify without having to disassemble the heater which is the door to be defective with an active diagnosis etc

[oakley1]

I made the diagnosis and I actually percentages strange opening closing... The starter motor works but I think that the door is locked. I just have to figure out which one is it ? if you can access it from the outside, not removing it completely

[egs]

I'm going a bit by memory now, but the mixer should be mounted from the passenger side, just under the hood on the dashboard, you should get there by disassembling only the panel that covers that part. And ? a defect that they have all those machines. Only that parts of them, not by Fiat, then you should give him a change...

[oakley1]

Thanks . Cos? I have addressed . Pi? late start? to disassemble the bulkhead passenger side and see a little. Maybe the actions of the door from the diagnosis and I can see exactly where it is located.... And I hope to be able to change and make it work. Here in Sardinia, it's not cold cold, but you never know. You keep up to date

[ugoboss]

I'm going a bit by memory now, but the mixer should be mounted from the passenger side, just under the hood on the dashboard, you should get there by disassembling only the panel that covers that part. And ? a defect that they have all those machines. Only that parts of them, not by Fiat, then you should give him a change...

quote in full what has been said, the starter motor is on the passenger side and there you should get, the problem arises if you need to change the door that you have to remove the dashboard, but first' I advise you to take a learning position the doors in the diagnosis, you never know.

[oakley1]

Hi l learning portella only with official diagnosis?

[ugoboss]

you should do this even with fiat ecuscan or with autocom, you have to try.