The ALFA 147 , error P010F

[rebirthafterrevenge]

Hi guys, I have a 147 jtdm 150 bhp with this damn error P010F inconsistency mass air /mass air flow sensor

I did these tests: seen all the ic pipes and depression(they are ok)
changed the sensor, absolute pressure and mass air flow sensor! now what do I do?

Greetings and thanks

[angelolsp]

No, but you can delete it from the map? On the vag edc15, I have seen

[rebirthafterrevenge]

No, but you can delete it from the map? On the vag edc15, I have seen

I do not know it!
the car smokes black if you accelerate to insane!
if I accelerate in gear, do not smoke!

[frantik3]

problem is the egr and clean it, or replace it, and by a subsidiary (if you fap!!!!
However, the problem pringipale and the egr!!!!!

[sportknight]

I also think the egr..

[danny677]

egr blocked, must be disassembled and cleaned, you will see what you find hehe

[rebirthafterrevenge]

The Egr is closed with a flange and disabled in the ecu, 80,000 km f?. the find.. my car did the fap..

[chicco]

but the values you see in the diagnosis of the maf are consistent or you get strange values?

[progresso]

that year? the car is good or not makes? see also valve engine shut-off sleeve and lower intercooler usually the slot on the pin mounted on the gearbox where and connected to the engine ground, or if you put the plate on the egr valve check it out as there is a hole in it often, I see thin, and with the condensation forano

[rebirthafterrevenge]

mass air ? ok and ? identical to the goal! ic controlled not lose! the car if I turn off and turn on it again and then after a p? goes into recovery ! the error in the cut off at 2150 rpm. so no acceleration! smoke black only crazy if you accelerated! with gears if you pull a non-smoker .. bah. that defect strange..