Solder pin spring on schedule

[jared_poe]

Guys I have to solder the pin to the spring on the schedule of the bdm, those bosch no problem, but for those of siemens and marelli, which has very close... what equipment we want to? you just need a welder and hand firm?

[msport (exil77grande)]

well, let's say that the experience,oviamnete pond up and a good welder.

[salvatoreragonese]

well, let's say that the experience,oviamnete pond up and a good welder.

good evening to all. exil77 I apologize if I'm reviving this post but I wanted to know if anyone has the diagrams of how you weld the tips in spring vistoo that a few days ago I got the ktag and the template and I wanted to start moving some step
for the moment, thank you

[cinqueturbo]

good evening to all. exil77 I apologize if I'm reviving this post but I wanted to know if anyone has the diagrams of how you weld the tips in spring vistoo that a few days ago I got the ktag and the template and I wanted to start moving some step
for the moment, thank you

I don't understand that diagram you need, you have to solder the needles on the board New or solder the tab of the ECU?

[salvatoreragonese]

I don't understand that diagram you need, you have to solder the needles on the board New or solder the tab of the ECU?

hello cinqueturbo I have to solder the needles on the ticket pero I don't know where they go, and then the e xxx that I got without the use of needles, but the weld has a hole in one of the four corners, and a point of reference?

[cinqueturbo]

hello cinqueturbo I have to solder the needles on the ticket pero I don't know where they go, and then the e xxx that I got without the use of needles, but the weld has a hole in one of the four corners, and a point of reference?

I am puzzled..
even now I understand that stupid you need to solder the needles in e xxx..
see if this you and useful to boo..

66390d1307403053bdm100b.jpg

[Gianpy80]

I confirm.. I recommend you to use a soldering iron with a low voltage with a fine tip, and of course the end of the pond.

[egs]

I agree with msport, but I also add a Good cream flux....

[jared_poe]

instead, to keep the pin in the right position? to solder them perfectly perpendicular.... I e xxx bosch I "traced" holes on a card to keep in place the pin, not me ? come think of any better solution...

[V.V.]

Eye out for? with the flux that fry and pu? to damage if you don't know how to use it! The method of tracing the holes on the card ? even my, at times I have also used sheets, 0.2 mm of dough sinks to keep the position of the pin!