unable to write to the Suzuki Grand Vitara 1.9 dci EDC16c3

[mirks]

Hello guys, I just wanted to let you know that this car, I was not able to read it in the serial but only with BDM,
despite being on galletto v2, magpro, was present.

the reading I had to do it with the protocol renault megane 2, and ? went perfect

rewrite it, given that they have access codes for different writing, not c'? been so if not with BDM

Hello

[explode82]

hello, I have made 3 and all from serial port without problems,of course, after writing, you can use the tool key suzuky

[magi1984]

I have made 3, defappate all bdm why? with kess original does not read nor write because of the coding injectors, although in the program of the kess there is written that it reads from the obd

[mecdoc]

hello I have made
3, and all from serial port without problems,of course, after writing, you can use the tool key suzuky

hello Raffaele where I can take this tool key suzuky

[magi1984]

? a function of the rooster v2

[mecdoc]

ok, but even the rooster clone has?

[magi1984]

of course

[explode82]

it is in the top of the subsection, suzuki together with the drive models are supported,in fact, that I have done I have done with the cock,the kess I have it,but as soon as I understood I test to see if the reads and the writes the kess.........that goes wrong I'm going to cock XD

[MKIII]

Hi guys, the tool of the rooster if I'm not mistaken, you use it only for the version with remote control rectangular, for instance, for version normal key with two buttons open and close need the' SDT suzuki with cable immobilizer why? each serial programming of this car you have to align the ecu of the immo with the engine,
the codes for the injectors, they are not lost.