eprom programmer,what to do

[sportknight]

so guys,first of all, I would like to figure out what to do with an eprom programmer

I can, for example, place the edc15 in the case of the block?

can I remap the ecu pi? old type motronic etc?

which programmer should I take?

I saw that there are x-progr,willem,wellon,top3000,upa, etc.

which would you recommend for me to spend not so much?

[cinqueturbo]

I recommended year:

LAB TOOL 48XP

FOR THE PROGRAMMER EEPROM SPEND MORE BUT GET THE TOP AND IS REALLY SMART BECAUSE IT TELLS YOU WHICH PIN MAY NOT BE MAKING GOOD CONTACT

these are the exact words..

can read and write a lot of Eprom and chip, see the features...

[sportknight]

Where can I find it?

[cinqueturbo]

Hello! you or just answer...

[sportknight]

the labtop can not find it,I saw the x-prog

can do to the case? do I need more? to be on the safe side with the edc15

[sportknight]

no one can give me an advice?

I need a programmer that does not cost much and that will allow me to restore the edc15 and maybe some interface that you sputtan...

[alfajtd]

the edc15 bring you to the place in boot mode...

I have never had need? of dissaldarle...

anyway, okay any programmer that face those eprom with its adaptor...
see you around what you find according to your budget and buy it.

[sportknight]

a,ok,thanks, good to know

that eprom must do anyway to be good? that eprom are needed in this field? cos? I ruler

[sportknight]

I saw willem but I noticed that the power supply ? usb but the data are parallel then I don't know how to connect it to my current laptop..

confirmed?

[legendaryslave]

I saw willem but I noticed that the power supply ? usb but the data are parallel then I don't know how to connect it to my current laptop..

confirmed?

are you council or the upa very valid use for many years also the xprog goes very well ? for some years I have taken the gx4 and I have to say that he is fine I do not recommend the willem ache if ? was my first programmer