myth 1.3 Mjet luca stanca does not go the cruise

[coma]

hi guys, it's not? how many of you can be successful, but after the luca stanca of this car, it does not work on the pi? the cruise control
The light on the picture comes on, I f? to change the speed? set but not active.
in the diagnosis with TEXA) no error and no chance? alignment CAN.
Of course the problem is ? presented immediately after the luca stanca, and then I added a edit soft

I enclose ori (read with galletto v2 clone so I think it is a virtual reade) + luca stanca/mod

[FidodidoTuning]

I've done a lot of this ever happened,I would be curosio to see the file.
? done with sw or manual?

[coma]

Hello, ? the fact in the manual.
for the file currently you can't see it, but if there are problems I can postartelo on your ****
expect some info from the moderators

[matd82]

I would like to see it also I grzzzz

[coma]

the file ? annex!!!!

[magi1984]

tomorrow as soon as I have time we look at you, I place a test file,then let me know if it goes

[coma]

The machine will come back? in the workshop after the 6th of January.
Then before I can do the tests.
Thanks anyway in the meantime!!

[magi1984]

here is the file, your were mapped, no, if you want to use it you need to re-map
? the first that happens to me with cruise control ? a try...let us know how it goes if you try it out

[angelo]

Maybe you should try to put it back ori and then enter the diagnosis to see if there are any errors, I ? often happened to that car defappate do not store errors, then remittances ori then seen is the one on the FAP (which is obvious that there is) that something else maybe.

[FidodidoTuning]

Questk problem and is typical vag group
Ecusafe you delete the entire area dtc
In fact, if the sieves mass air flow sensor or other
You don't have any error and this is not good
But not this is the case
However, as a first test, I would put it and you can see immediately if it goes to the place.