info bdm

[vincenzot]

I bought a bdm 100? I noticed that, but you have to solder the schedule on the ecu or you have to buy the needles to be welded and then the schedule are female, and the flat and female how to connect them I have to buy an adapter, or to force the template.thanks

[cinqueturbo]

I bought a bdm 100? I noticed that, but you have to solder the schedule on the ecu or you have to buy the needles to be welded and then the schedule are female, and the flat and female how to connect them I have to buy an adapter, or to force the template.thanks

S? the only BDM100 1255 with the coupons normal,
must be welded,
for the problem of the connection just go to an electronics store and you buy a strip of pins such as those on the Marelli,
Then if you buy the template with the coupons spring works better, and more? quickly..
Ps. attentive to the flat if not, and the forum..

[vincenzot]

hello thanks, but that part of salerno six

[paulocx]

seems to be a programmer exelente

[fuorigiri12000]

S? the only BDM100 1255 with the coupons normal,
must be welded,
for the problem of the connection just go to an electronics store and you buy a strip of pins such as those on the Marelli,
Then if you buy the template with the coupons spring works better, and more? quickly..
Ps. attentive to the flat if not, and the forum..

I confirm this works much better.

[Mr.Flash]

for service information.... the strip of pin ? also called strip and the step of 2.54 for the bosch and 1.27 for the marelli

[Frate]

I said Cinqueturbo attentive to the flat, you might have the one with reversed power supply

[Mr.Flash]

not only the flat also to the schedule, 2 look the same but are connected differently , check with a multimeter... (sometimes over there? written by no and not ? easy to identify them)

[thierry30200]

Thanks for the info

[thierry30200]

and participation