creating cable boot

[giary74]

all of those use the k line,then if there colleagues also the can is also good for the can...

I would not say nonsense, but this cable you could use to read and write in the boot of the IAW 59F?

[zioweb]

Mucho interesting

[sportknight]

of course you can

[micheleyr6]

friends...I understand that puts in the boot, the ecu, but kindly explained how to use this cable??

and what ecu does it work?

[ugoboss]

hello,you can use it in all of those ecu's where you need a cable to read to tour, almost all of the interfaces that you buy already have the cables, but many don't have the attack the obd, this is similar to the one that they give you with the MPPS v18, what is more, it has a switch to power or not the ecu, even if many found them to be wrong with the power supply to the contrary, namely, fuel always the ecu and when you turn on the power switch to supply power to the connected instrument (usually should be the opposite), however, this and a cable, always useful.

[micheleyr6]

thanks boos always very helpful...
if I have understood correctly then this is when to the a interface with the obd and you want to read a ecu on the bench in boot mode...
I believed that you could put the ecu in boot from the diagnostic socket,...
eee it would have been nice

[ugoboss]

hello, if you want to read the ecu on the bench by putting it in bootmode without opening it you have to use the technology bench that have become all the interfaces of the latest generation as well as the official clone that I know ( but I am not no one) ec only the KTM bench, I have and it works fine.